✔ Communication Protocol

What is DNP3? Reliable communication for wide-area networks

DNP3 (Distributed Network Protocol) was developed for communication between a control centre and field RTUs in wide-area systems such as power distribution, water and gas networks.

It is especially common in North America and Australia. In Turkey and Europe, the same job on the energy side is mostly done by IEC 60870-5-104.

Highlights

  • Serial and TCP/IP
  • TCP 20000
  • Time-stamped events
  • Unsolicited reporting
  • Secure Authentication

How does it work?

The central system is called the master and the field device the outstation. When a value changes, the outstation stores it in its own memory together with a time stamp. If the link drops, events are not lost; they are sent in order when the connection returns.

The outstation can also report changes without being asked (unsolicited response). This avoids constant polling and keeps the line less busy.

Hardware architecture

Field Devicesrelays, sensorsRTU / Outstationevent memoryCommunicationradio, fibre, 4GDNP3 MasterSCADA centre
  • RTU / outstation: Collects field signals and stores events with time stamps.
  • Time synchronisation: RTU clocks must be synchronised via GPS or the network for event times to be correct.
  • Communication medium: Serial (RS-232/485), licensed radio, fibre or 4G. DNP3 copes well with weak and intermittent links.
  • Power: Battery- or solar-backed supplies are common at remote sites.

Cable and material selection

  • Serial connections: 120 Ω shielded twisted pair for RS-485; RS-232 only for short links (about 15 m).
  • Substations and between buildings: Fibre optic; immune to electrical noise and potential differences.
  • Radio and 4G: Use an external antenna, low-loss antenna cable and a lightning protector; keep the antenna cable as short as possible.
  • Outdoors: The RTU enclosure should suit a wide temperature range and be protected against moisture and dust (e.g. IP65).

Advantages and disadvantages

Advantages

  • Time-stamped event records with correct sequence
  • No data loss when the link drops
  • Report-by-exception saves bandwidth
  • Reliable on weak and intermittent links
  • Secure Authentication option

Disadvantages

  • More complex to configure than Modbus
  • IEC 104 is more common for energy in Turkey
  • Supported subset level must be checked for compatibility
  • Needs expertise and test tools

DNP3 compared with similar protocols

DNP3IEC 60870-5-104Modbus TCP
Common regionNorth America, AustraliaEurope, TurkeyWorldwide
Time stampsYesYesNo
Report on changeYesYesNo (constant polling)
Buffers data when the link dropsYesDepends on deviceNo
Setup difficultyMedium–highMediumLow

How to test it

  1. Match master and outstation addresses, port and point list on both sides.
  2. Run an integrity poll and confirm all points arrive.
  3. Change a value in the field and check that the event arrives with the correct time stamp.
  4. Briefly cut the link and reconnect; confirm the events in between arrive without loss.

Testing with ATLAS SCADA

When DNP3 data is converted to IEC 104 or Modbus TCP through a gateway, you can test that data with ATLAS SCADA and watch the values directly on the SCADA screen.

Let's review your project together

Let's work out together which architecture, hardware and cabling fit your facility.

Let's talk about your project